HP Brocade 8/12c Brocade Fabric OS Documentation Updates - Supporting Fabric O - Page 27

Chapter Fabric OS Commands Reference 5 In this chapter The updates in this chapter are for the Fabric OS Command Reference. • Documentation updates for Fabric OS v6.4.0 15 • Documentation updates for Fabric OS v6.4.1 28 • Documentation updates for Fabric OS v6.4.2 34 • Documentation updates for Fabric OS v6.4.3 36 Documentation updates for Fabric OS v6.4.0 NOTE The updates in this section are for the Fabric OS Command Reference, publication number 53-1001764-01, published March 2010 and supporting Fabric OS v6.4.0. Updates refer to the help pages for the commands indicated and the associated man pages on the switch. ceePortLoopbackTest/portLoopbackTest The man pages and corresponding pages in the Command Reference should be updated with the following note: This diagnostic cannot be run on an operational switch. You must disable the switch using the chassisDisable command before you can run this test. After the test completes, re-enable the switch using the chassisEnable command. Do not use the switchDisable command followed by manually shutting down the ports before running the test. This will not work because executing switchEnable after the test completes will leave the ports in the same state as before. The only way to bring the ports down before running the test and back up after the test completes is by using the chassisDisable command followed by the chassisEnable command. passwd The syntax for the following example has been corrected as follows: To change the password for user "brocadeUser" from an admin account noninteractively: switch:admin> passwd brocadeUser -old brcdPasswd -new mynewPasswd Password changed. Saving password to stable storage. Password saved to stable storage successfully. Fabric OS Documentation Updates 15 53-1002063-09