HP Brocade 8/12c Brocade Fabric OS Documentation Updates - Supporting Fabric O - Page 45

portLoopBackTest 5 To configure Edge hold time on an enabled switch: Switch:admin> configure Not all options will be available on an enabled switch. To disable the switch, use the "switchDisable" command. Configure... Fabric parameters (yes, y, no, n): [no] yes Configure edge hold time (yes, y, no, n): [no] yes Edge hold time: (100..500) [220] System services (yes, y, no, n): [no] ssl attributes (yes, y, no, n): [no] rpcd attributes (yes, y, no, n): [no] webtools attributes (yes, y, no, n): [no] System (yes, y, no, n): [no] portLoopBackTest Augment the note section of the portLoopBackTest help pages as follows: This diagnostic cannot be run on an operational switch. You must disable the switch using the chassisDisable command before you can run this test. After the test completes, re-enable the switch using the chassisEnable command. Do NOT use the switchDisable command followed by manually shutting down the ports before running the test. This will not work, because executing switchEnable, after the test completes, will leave the ports in the same state as before. The only way to bring the ports down before running the test and back up after the test completes is by using the chassisDisable command followed by the chassisEnable command turboRamTest :Augment the note section of the turboRamTest help pages as follows: This diagnostic cannot be run on an operational switch. You must disable the switch using the chassisDisable command before you can run this test. After the test completes, re-enable the switch using the chassisEnable command. portLedTest :Augment the note section of the portLedtestTest help pages as follows: This diagnostic cannot be run on an operational switch. You must disable the switch using the chassisDisable command before you can run this test. After the test completes, re-enable the switch using the chassisEnable command. Fabric OS Documentation Updates 33 53-1002063-09