HP Color LaserJet Enterprise flow MFP M880 Hole Punch Kit Installation Guide - Page 6
Responsibly dispose of the failed assembly.
 |
View all HP Color LaserJet Enterprise flow MFP M880 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
27 28 Slightly lift up on the punch hole assembly (callout 1), and then disengage the sheet-metal support bracket (callout 2). NOTE: The punch hole assembly is still fastened to the accessory chassis, but you should be able to disengage the support bracket. Remove one screw. 29 30 Remove one screw. 31 ZZZKSFRPVXSSRUWFRORUOM0 ZZZKSFRPVXSSRUWFRORUOMƮRZ0)30 /HDHVWRSULPHUR Lift the assembly up to release it, and then remove the assembly. Responsibly dispose of the failed assembly. Unpack the replacement assembly. If present, remove all packing materials. Installation is the reverse of removal. NOTE: See the special installation instructions section on the following pages after installing the replacement assembly. 6
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8 -
9 -
10 -
11 -
12
 |
 |
6
29
27
30
28
±
²
31
$±:²³´µ¶·¸±
&=···´µ¶·¸±
¹
±
Slightly lift up on the punch hole assembly (callout 1), and then
disengage the sheet-metal support bracket (callout 2).
NOTE
: The punch hole assembly is still fastened to the accessory
chassis, but you should be able to disengage the support bracket.
Remove one screw.
Remove one screw.
Lift the assembly up to release it, and then remove the assembly.
Responsibly dispose of the failed assembly.
Unpack the replacement assembly. If present, remove all packing
materials.
Installation is the reverse of removal.
NOTE
: See the special installation instructions section on the
following pages after installing the replacement assembly.