HP Color LaserJet Enterprise flow MFP M880 Hole Punch Kit Installation Guide - Page 7

Special installation instructions 1 2 5HDUVLGH Reconnect the finishing accessory to the product. Turn the power on. After the product has initialized, send a hole punch print job to the accessory. Check the printed page and verify that the holes are punched in the correct page location. 3DSHUIHHG GLUHFWLRQ )URQWVLGH Punch adjustment is required when the punch holes are misaligned. If the holes are not aligned, identify in which direction the punched hole adjustment is required. This figure shows the punched hole misaligned to the left. 3 4 5HDUVLGH  3DSHUIHHG GLUHFWLRQ PP PP Follow these steps to adjust for skewed hole alignment. This adjustment procedure only moves the front portion of the punch to move the front hole in alignment with the rear hole. a. Open the punch door and upper cover. b. Loosen the adjustment screw (callout 1), and then move the punch plate to the right or to the left as necessary to bring the front punched hole in alignment with the rear hole. c. Tighten the adjustment screw. IMPORTANT: Fully tighten the adjustment screw after making each adjustment and before closing the upper cover to make sure that the punch position does not move. d. Close the punch door and upper cover. e. Print five test pages and continue adjusting until all the holes are aligned on the page. f. After adjustment is completed, print 25 test pages to assure alignment remains constant. NOTE: If some pages have skewed holes while others do not, the problem is a skew in the paper and not the punch. 7 )URQWVLGH Correct punch hole alignment. NOTE: The 12 mm (.47 in) distance from the trailing edge of the paper is calculated in firmware and cannot be adjusted.