HP Color LaserJet Pro M180-M181 User Guide - Page 93
Interpret control-panel light patterns (LED control panels only)
View all HP Color LaserJet Pro M180-M181 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Interpret control-panel light patterns (LED control panels only) If the printer requires user confirmation, the LED control panel alternates between Go and a two-digit status code. If the printer requires attention, the LED control panel alternates between Er and a two-digit error code. Use the table below to determine any issues with the printer. Table 9-1 Status-light legend Symbol for "light off" Symbol for "light on" Symbol for "light blinking" Table 9-2 Control-panel light patterns Light status Error code State of the printer Action The Attention light is Go/01 blinking. The printer is in manual-feed mode. Load the correct paper type and size into the input tray. Press the Start Mono Copy button to continue. Go/02 Go/03 Er/01 Er/02 Er/03 Er/04 Er/05 Er/06 Er/25 Er/26 Er/81 The printer is processing a manual duplex job. Load the pages into the input tray to print the second sides. Press the Start Mono Copy button to continue. Print job is different from the user's settings. Load plain paper or press the Start Mono Copy button to continue with the paper currently loaded. The input tray is empty. Load the tray. A door is open. Verify that the top cover is fully closed. The printer failed to pick a sheet of paper to print. Press Start Mono Copy to continue. Paper is jammed in the input tray. Clear the jam. Paper is jammed in the toner cartridge area. Clear the jam. Paper is jammed in the output bin area. Clear the jam. The loaded paper is not the size needed for the print job. Replace the paper, or press Start Mono Copy to continue with the size currently loaded. The printer has experienced a general engine error. Press Start Mono Copy to continue. If the error repeats, turn off the printer. Wait 30 seconds, and then turn on the printer. Incorrect firmware has been loaded. Press Start Mono Copy correct firmware. to continue. Load the ENWW Interpret control-panel light patterns (LED control panels only) 83