HP D2200sb HP StorageWorks D2200sb PCIe Storage Blade Maintenance and Service - Page 24

Hard drive blank

Get HP D2200sb PDF manuals and user guides View all HP D2200sb manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

CAUTION: To prevent damage to electrical components, properly ground the server blade before beginning any installation procedure. Improper grounding can cause ESD. CAUTION: Do not operate the storage blade with the access panel open or removed. Operating the storage blade in this manner results in improper airflow and improper cooling that can lead to thermal damage. To install the component: 1. Place the access panel on top of the storage blade. Allow the panel to extend past the rear of the storage blade approximately 0.8 cm (0.2 in). 2. Slide the access panel toward the front of the storage blade. The access panel locks into position. Hard drive blank WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system components to cool before touching them. CAUTION: To prevent damage to electrical components, properly ground the storage blade before beginning any installation procedure. Improper grounding can cause ESD. To remove the component: 1. Open the hard drive drawer. Removal and replacement procedures 24

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
Removal and replacement procedures
24
CAUTION:
To prevent damage to electrical components, properly ground the server blade
before beginning any installation procedure. Improper grounding can cause ESD.
CAUTION:
Do not operate the storage blade with the access panel open or removed.
Operating the storage blade in this manner results in improper airflow and improper cooling
that can lead to thermal damage.
To install the component:
1.
Place the access panel on top of the storage blade. Allow the panel to extend past the rear of the
storage blade approximately 0.8 cm (0.2 in).
2.
Slide the access panel toward the front of the storage blade. The access panel locks into position.
Hard drive blank
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION:
To prevent damage to electrical components, properly ground the storage blade
before beginning any installation procedure. Improper grounding can cause ESD.
To remove the component:
1.
Open the hard drive drawer.