HP D2D HP StorageWorks Linux and UNIX configuration guide for D2D Backup Syste - Page 33
HP-UX 11i V2, To create device files for the target devices, type the following
View all HP D2D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
9. If the device type shown above is UNKNOWN instead of TAPE or AUTOCH then you must configure the stape and schgr modules for the HP-UX kernel. This can be done as follows: HP-UX 11i V2 # kcmodule -B stape=static schgr=static * The automatic 'backup' configuration has been updated. Module State Cause schgr (now) static best (next boot) static explicit stape (now) static best (next boot) static explicit HP-UX 11i V3 # kcmodule -h -B stape=static estape=static schgr=static eschgr=static * The automatic 'backup' configuration has been updated. Module State Cause schgr (now) static best (next boot) static explicit stape (now) static best (next boot) static explicit eschgr (now) static best (next boot) static explicit estape (now) static best (next boot) static explicit 10. To create device files for the target devices, type the following: # insf -H 255 D2D Backup System 33