HP D2D HP StorageWorks Linux and UNIX configuration guide for D2D Backup Syste - Page 48

2. To verify devices files for the iSCSI target device have been created, use these commands: lrwxrwxrwx 1 root root 87 Apr 21 16:33 c2t500110AE1443192Ed0 devices/pci@7c0/pci@0/pci@9/SUNW,qlc@0/ fp@0,0/sgen@w500110ae1443192e,0:changer Here you can see device file c2t500110AE1443192Ed0 has been created for the changer element. # ls -l /dev/rmt/*cb lrwxrwxrwx 1 root root 77 Apr 21 16:33 /dev/rmt/2cb -> ../../devices/pci@7c0/pci@0/pci@9/SUNW,qlc@0/fp@0,0/ st@w500110a057bb1b32,0:cb Configuring the HP D2D Backup System for NAS (NFS) The D2D Backup System NAS interface should be configured to use NFS as the Access Protocol when backing up data using Solaris. The NFS share can then be mounted in Solaris using the mount command. For example: # mount -F nfs -o vers=3 192.168.0.100:/nas/D2DBackupShare /mnt/D2DBackupShare The D2D Backup System supports NFSv3. To explicitly mount the D2D Backup System using NFSv3, the following syntax should be used: # mount -F nfs -o vers=3 x.x.x.x:/ Controlling an HP StorageWorks D2D Backup System using Solaris The HP StorageWorks D2D Backup System appears to the Solaris operating system as a changer device and Ultrium tape drive. The changer device represents the robotics within the library and can be controlled from the console using a command called mtx. mtx is not installed with Solaris by default but it can be downloaded and installed from sourceforge.net The following examples illustrate how to complete common tasks with the HP StorageWorks D2D Backup System. • Verify you are controlling the correct library • Review the media • Load a cartridge into the tape drive • Unload a cartridge from the tape drive • Move a cartridge to the mail slot • Move a cartridge from the mail slot 48 Solaris (x86 and SPARC)