HP Dc5750 HP Compaq dc5750 Business PC Service Reference Guide, 1st Edition - Page 135
Processor,
UPC - 883585056446
View all HP Dc5750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 135 highlights
Removal and Replacement Procedures- Small Form Factor (SFF) Chassis 7.17 Processor 1. Prepare the computer for disassembly (Section 7.1). 2. Remove the access panel(Section 7.3). 3. Remove the fan shroud (Section 7.11). 4. Remove the heatsink (Section 7.16). 5. Raise the locking lever to its fully open position 1. 6. Carefully lift the processor from the socket 2. Ä CAUTION: Do NOT handle the pins in the processor. These pins are very fragile and handling them could cause irreparable damage. Once pins are damaged it may be necessary to replace the processor. To install a new processor reverse the removal process. If reusing the existing heatsink, go to step 1. If using a new heatsink, go to step 4. 1. If reusing the existing heatsink, clean the bottom of the heatsink with the alcohol pad provided in the spares kit. Ä CAUTION: Before reinstalling the heatsink you must clean the top of the processor and the bottom of the heatsink with an alcohol pad supplied in the spares kit. After the alcohol has evaporated, apply thermal grease to the top of the processor from the syringe supplied in the spares kit. 2. Apply the thermal grease provided in the spares kit to the top of the processor and install the heatsink atop the processor. 3. Go to step 5. 4. If using a new heatsink, remove the protective covering from the bottom of the heatsink and place it in position atop the processor. 5. Secure the heatsink to the system board and system board tray with the 4 captive screws and attach the heatsink control cable to the system board. Service Reference Guide, dc5750 437963-001 7-29