HP Designjet 230 Service Manual - Page 146

Paper + Error + Film + Ready: Failure of centronics READ. Firmware error or faulty electronics module. Steady 1349 Steady 1356 Paper + Error + Fast + Load Media: Error in XĆaxis encoder quadrature (media-axis). Possible causes are: D Incorrect routing of the motor cables. D Electrical noise in motors. D Faulty motor encoder. D Motor received an electrostatic discharge while operating. Paper + Error + Fast + Special: Contents of the EEROM have been lost. Steady 1357 D Perform the electrical test. If it fails, the main PCA is faulty. D Don't rule out the fact that any new service test that you perform may corrupt the EEROM. For more information ' page 8Ć27, w EEROM Errors. Error + Film + Fast + Load Media: Error in encoderĆstrip quadrature (carriage axis). Possible causes are: Steady 3456 D Incorrect routing of the motor cables. D Trailing cable is faulty or badly connected. D Faulty carriage. D Motor received an electrostatic discharge while operating. Paper + Cartridges + Error + Film + Fast: CartridgeĆalignment firmware error. Try one or more of the following: Steady 12345 D Turn the plotter off, and then on again to see if the problem disappears. D Ensure that the cartridges are correctly seated. D Replace cartridges. D If the problem remains, consult recent service notes for a possible solution. D If no service note deals with this error, report the problem to your HP Response Center. Note conditions and actions before error occurred. Include setup sheet and service configuration plot in report. Steady 13456 Paper + Error + Film + Fast + Load Media: Error in bailĆlift mechanism. The bailĆlift system is unable to raise or lower the bail. (It is the carriage that tests to see whether the bail is in the correct position by trying to knock against it.) D Check the bailĆlift system to see if it is working correctly. D Use the bail cycle test to help troubleshoot. For more precise troubleshooting ' page 8Ć19, w System Errors. 8Ć12 Troubleshooting C4699Ć90000