HP Designjet 230 Service Manual - Page 157
System Errors for the DesignJet 330 and 350C Plotters
View all HP Designjet 230 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 157 highlights
330 350C System Errors for the DesignJet 330 and 350C Plotters The DesignJet 330 and 350C plotters have many failure modes that cause system errors. Many are due to electrical problems, others electronic, and some mechanical. To more precisely troubleshoot the system error, you may be able to find out what line of the firmware code the error appeared, and interpret this line; 1 If possible, print the service configuration plot (see ' page 8Ć50). The last system error, and the line number of the system error are printed on this plot. 2 See if the line number also appears in the following table. (Make sure that you also know which firmware revision the plotter is using, since a given line number corresponds to different lines in different revisions.) Filename testmode.c testmode.c testmode.c testmode.c testmode.c testmode.c testmode.c Line Number Firmware A.01.00 2499 3614 3559 3574 3592 3601 Failure (and most frequent causes) YĆaxis servo error during bench run. X/YĆaxis servo error during bench run. Cartridge continuity: D Cartridges badly seated. D Faulty or badly connected trailing cable. D Dirty carriage flex circuit. D Faulty carriage. D Faulty electronics module. Secondary Fibis test failed: D Faulty electronics module. Error in swathĆRAM test: D Faulty electronics module Error in cartridgeĆvoltage regulation: D Faulty or badly connected trailing cable. D Faulty carriage. D Faulty electronics module. Error in A/D convertor test: D Faulty trailing cable. D Faulty carriage. C4699Ć90000 Troubleshooting 8Ć23