HP ENVY 13-ab000 Envy Notebook PC model numbers 13-ab001 through 13-ab099; CTO - Page 41

Solid-state drive Description 1-TB, M.2 2280, PCIE, 3×4 SS NVMe solid-state drive supporting TLC CN 512-GB, M.2 2280, PCIE, 3×4 SS NVMe solid-state drive supporting TLC CN 256-GB, M.2 2280, PCIE, 3×4 SS NVMe solid-state drive supporting TLC CN 128-GB, M.2 2280, SATA-3 solid-state drive Spare part number 865697-003 847110-011 847109-013 827560-029 Before removing the solid-state drive, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. 3. Disconnect all external devices from the computer. 4. Remove the bottom cover (see Bottom cover on page 27). 5. Disconnect the battery cable from the system board (see Battery on page 29). Remove the solid-state drive: 1. Remove the Phillips PM2.0×3.2 screw (1) that secures the solid-state drive to the computer. (The solid- state drive tilts up.) 2. Remove the solid-state drive (2) by pulling the drive away from the slot at an angle. Reverse this procedure to install the solid-state drive. Component replacement procedures 33