HP ENVY 17-2090nr HP ENVY 17 (model numbers 2000 through 2099) - Maintenance a - Page 53

to lift the rear edge of the secondary hard drive until it rests at an angle

Get HP ENVY 17-2090nr PDF manuals and user guides View all HP ENVY 17-2090nr manuals
Add to My Manuals
Save this manual to your list of manuals

Page 53 highlights

Remove the secondary hard drive: 1. Disconnect the secondary hard drive cable from the system board, and then release the cable from the clips and routing channel built into the base enclosure. 2. Remove the four Phillips PM2.5×6.0 screws that secure the secondary hard drive to the computer. 3. Use the Mylar tab (1) to lift the rear edge of the secondary hard drive until it rests at an angle. Component replacement procedures 45

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
Remove the secondary hard drive:
1.
Disconnect the secondary hard drive cable from the system board, and then release the cable
from the clips and routing channel built into the base enclosure.
2.
Remove the four Phillips PM2.5×6.0 screws that secure the secondary hard drive to the computer.
3.
Use the Mylar tab
(1)
to lift the rear edge of the secondary hard drive until it rests at an angle.
Component replacement procedures
45