HP ENVY m6-1184ca HP ENVY m6 Notebook PC Maintenance and Service Guide - Page 72
Solid-state drive, Remove the Phillips PM2.0×3.0 screw
View all HP ENVY m6-1184ca manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Solid-state drive Description 32-GB solid-state drive (for use only on computer models equipped with an Intel processor) Spare part number 686927-001 Before removing the solid-state drive, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. 3. Disconnect all external devices from the computer. 4. Remove the battery (see Battery on page 47). 5. Remove the service cover (see Hard drive on page 48). 6. Remove the wireless module compartment cover (see WLAN module on page 61). Remove the solid-state drive: 1. Remove the Phillips PM2.0×3.0 screw (1) that secures the solid-state drive to the base enclosure. (The solid-state drive tilts up.) 2. Remove the solid-state drive by pulling the drive away from the slot at an angle (2). Reverse this procedure to install the solid-state drive. 64 Chapter 4 Removal and replacement procedures