HP EliteBook Revolve 810 EliteBook Revolve 810 G3 Maintenance and Service Guid - Page 63
Fan/heat sink assembly, Phillips PM2.0×6.5 screws
View all HP EliteBook Revolve 810 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
9. Remove the system board (4). Reverse this procedure to install the system board. Fan/heat sink assembly Description Fan/heat sink assembly (includes replacement thermal material) Spare part number 801798-001 Before removing the fan/heat sink assembly, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. 3. Disconnect all external devices from the computer. 4. Remove the battery (see Battery on page 29), and then remove the following components: a. Service cover (see Service cover on page 30) b. Keyboard (see Keyboard on page 41) c. Bottom cover (see Bottom cover on page 44) d. System board (see System board on page 50) Remove the fan/heat sink assembly: 1. Disconnect the fan cable (1) from the system board. 2. Following the 1, 2, 3, 4 sequence stamped into the fan/heat sink assembly, loosen the four captive Phillips PM2.0×6.5 screws (2) that secure the fan/heat sink assembly to the system board. Component replacement procedures 53