HP Integrity rx5670 Windows Integrity nPartition Guide - Page 84
Remove (delete) an nPartition, Step 5.
View all HP Integrity rx5670 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Using Other Tools for Managing nPartitions nPartition-level tasks # parstatus -V -p1 [Partition] Partition Number : 1 Partition Name : hostname05 Status : inactive IP address : Prmary Boot Path : 4/0/1/0/0.9 ALternate Boot Path : 0/0/0/0/0/0/0/0.0.0 HA Alternate Boot Path : 0/0/0/0/0/0/0/0.0.0 PDC Revision : 104.1 IODCH Version : 23664 CPU Speed : 552 MHz Core Cell : ? Core Cell Alternate : 0. cab0,cell4 1. cab0,cell6 [Cell] CPU Memory Use OK/ (GB) Core On Hardware Actual Failed/ OK/ cell Next Par Location Usage Max Failed Connected To Capable Boot Num cab0,cell4 inactive 4/0/4 2.0/ 0.0 cab 0,bay0,chassis3 yes yes 1 cab0,cell6 inactive 4/0/4 2.0/ 0.0 cab 0,bay1,chassis1 yes yes 1 .... Step 5. Boot your newly-created nPartition past boot-is-blocked to make it active and make its system boot environment available. Use the BO command at the management processor Command menu to boot the nPartition. Once the nPartition is booted, you can access its system boot environment through its console. Use the management processor Console menu (enter CO at the management processor Main Menu). Remove (delete) an nPartition Deleting an nPartition causes all cells (and any I/O resources connected to the cells) that were assigned to the nPartition to be unassigned. As a result, all of these cells become available resources which can be assigned to any nPartition in the server complex. When removing an active nPartition, you must complete the procedure by performing a shutdown for reconfig (shutdown /s command) as soon as possible after initiating the nPartition removal. Unless you use the remote administration features supported by the Windows nPartition tools, you can delete only the local nPartition and inactive remote nPartitions. Remove an nPartition using the following procedure: Deleting an nPartition [par commands] From the command line, use the parremove command to delete (remove) an nPartition. Step 1. Use the parstatus -P command to list all nPartitions, and check the status (active or inactive) for the nPartition you plan to remove. 84 Chapter 4