HP Kayak XU 04xx HP Kayak XU Series 04xx, Familiarization guide - Page 15

Removing and Replacing the Internal Speaker Removing and Replacing the Internal Speaker Removing the Speaker Œ Ensure that the computer's power cord is disconnected from the computer.  Place the computer on its side. Unscrew the four screws at the bottom of the computer. Return the computer to its upright position. Ž To improve access to the internal speaker, disconnect the power cables from any connected mass storage devices. Then unclip the main power supply unit cable (thick black cable located on the righthand side) from the computer. From inside the computer, gently slide out the power supply unit towards the rear of the computer until it stops. Replacing the Speaker  Slide the power supply unit back into the computer. Ensure that the cables are flat and do not get trapped between the top of the power supply unit and the bottom of the computer. Clip the main power supply unit cable to the computer. Reconnect the power cables to any connected mass storage devices. Ž Place the computer on its side. Replace the four screws at the bottom of the  PC. Then return the computer to its upright position. ™ Reconnect the computer's power cord to the computer. ™ Push the internal speaker in the direction of the system board. Disconnect the internal speaker cable from the system board. Œ The internal speaker is held in place by two clips. Align the internal speaker up with the bottom clip, then push it towards you until it clicks in place. Connect the internal speaker cable to the system board. Two clips that hold the speaker in place.  15