HP Kayak XU 04xx HP Kayak XU Series 04xx, Familiarization guide - Page 18

Connecting to the LAN/SCSI Combination Board NOTE Connecting to the LAN/SCSI Combination Board The HP Kayak Series 0441 PC Workstation contains a SCSI/LAN 10BT/100TX combination board which is installed in PCI Slot 4. This combination board includes two connectors: • Wake On LAN (WOL) which enables a host computer, using Magic Packet technology, to remotely (over the network) power on computers (Remote Power On) or wake them up (Remote Wake Up) from energy-saving Sleep mode. For these functions to work, the WOL cable must be connected between the SCSI/LAN Combination board, located at the bottom righthand-side corner (J8) and the WOL connector on the system board (J20). • External Start connector which enables LAN activity, the SCSI LED activity on the front panel for SCSI hard disk drive accesses, and external SCSI cable detection. The external cable must be connected to the internal connector (J4) on the bottom right-hand-side of SCSI/LAN combination board to the HP External Start connector (R403) on the system board. LAN/SCSI Combination Board Three-pin connector to connect the WOL cable to the system board. Thirteen-pin connector to connect the external cable to the system board. Internal Wide SCSI connector (not used). Internal Narrow SCSI connector (used). Refer to page 9 to find out where the HP External Start and WOL connectors are located on the system board. Do not connect any devices to the Internal Narrow SCSI, and to the Internal Wide SCSI at the same time. If you do, this results in a badly "terminated" SCSI bus. In the HP Kayak XU and XW PC Workstations, only an Internal Narrow SCSI cable is provided. 18