HP Kayak XW A2-U2-W2 HP Kayak XW Series 04xx, Troubleshooting Your PC Workstat - Page 11

HP Kayak XW 0480 PC Workstation - Troubleshooting Your HP PC Workstation If Your PC Workstation Does Not Start Properly Clearing the If the PC Workstation then starts, but POST still persists in reporting an PC Workstation's error, clear the current configuration memory values and reinstall the Configuration Memory built-in default values: 1 Turn off the PC Workstation, disconnect the power cord, and remove the cover. Disconnect the PC Workstation from any telecommunications network. a Set the system board switch 6 (CLEAR CMOS) ON to clear the configuration. b Replace the cover, and reconnect only the power cable. c Turn on the PC Workstation. This will erase the CMOS memory. d Wait until the PC Workstation has started. A message will be displayed similar to this: "Configuration has been cleared, set switch Clear CMOS to the open position before rebooting." e Turn off the PC Workstation, disconnect the power cord, and remove the cover. f Set the system board switch 6 (CLEAR CMOS) UP to retain the configuration. 2 Replace the cover, and reconnect the power cord. 3 Switch on the PC Workstation. An error message will be displayed similar to the following: On your monitor: On your PC Workstation's LCD: Incorrect PC Configuration Error! POST 0012 The PC Workstation will stop. Press errors) and then press . (to view the system 4 Run Setup by pressing . CMOS default values will be automatically downloaded and saved. 5 Make any other changes you want and press configuration and exit from Setup. to save the English 11