HP LH4r HP Netserver LXr 8500 Rack Cabling Guide - Page 36
Step 3: Cable the LXr 8500 for Power
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Chapter 3 Procedure for Connecting and Routing Cables to the LXr 8500 and monitor for more than one server, attach the cables for the HP Console Switch to the server ports of the video card and the mouse and monitor ports. Check Whether Cable Lengths Limit Distances between the Server and Storage Sometimes data cable length or availability limits the distance between a peripheral component (such as the UPS or video monitor) and its associated server. Guidelines used by rack configuration tools in generating rack layouts take possible distance limitations into account. Check power and data cords supplied with peripherals to ensure you have cables that are long enough to attach each device. NOTE Be sure to leave sufficient data cable length to allow for cable management. See the section of this chapter "Managing and Routing Cables" and refer to Figure 3-10. Attach Data Cables to Other Components 1. Using the colored cable ties and labels attached to each data cable previously, connect each cable to its component. 2. Fasten cable connectors to each component using captive screws. Step 3: Cable the LXr 8500 for Power When all components have been mounted in the rack and their data cables connected, then the power cables can be attached. Attaching Server and Component Power Cables 1. Make sure all device power switches are off. 2. Attach the power cords for each device. ◊ Plug power cords into the receptacle in the server. ◊ Ensure sufficient cable to fully extend the server and route cables through the Cable Management Arm. ◊ Route the cables through the Cable Guide. ◊ Tie bundles of cables using hook-and-loop cable straps. 3. Plug components into the PDU beginning with the components which are lowest in the rack. If you are using more than one PDU or have a heavily 32