HP LH4r HP Netserver LXr 8500 Rack Cabling Guide - Page 48
Adjust cables between the Cable Management Arm and Cable Guide
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Chapter 3 Procedure for Connecting and Routing Cables to the LXr 8500 WARNING Before sliding the HP NetServer LXr 8500 out of the rack, make sure you extend the anti-tip foot from under the front of the rack. A tip-over hazard exists, so never slide more than one component out of the rack at a time. NOTE Do not remove the screws that hold the slides to the front columns of the rack. Slide the NetServer out by grasping the handle below the LCD control panel. To PCI Boards Extend the Cable Management Arm to ensure you have enough cable before routing cables through the Cable Guide Figure 3-10. Extend the Server to Adjust Cable Lengths Fully extend the NetServer (until it clicks) to determine how long the cable loop needs to be. See Figure 3-10. 5. Adjust cables between the Cable Management Arm and Cable Guide and tie-wrap them. 6. Gather extra lengths of cable and tie-wrap it into the metal Cable Guides on the column of the rack. 7. Tighten each of the hook-and-loop tie wraps to ensure they support the cables correctly. Slide the NetServer in carefully making sure cables do not 44