HP LH4r HP Netserver LXr 8500 Rack Cabling Guide - Page 47
A. Begin
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Chapter 3 Procedure for Connecting and Routing Cables to the LXr 8500 A. Begin with the Server all the way in B. Plug power and data cables into the back of the Server F. Drape cables through the fingers of the Cable Guide E. Tie wrap cables into the inner and outer sections of the Arm C. Gather cables at left and tie to Cable Management Arm flange D. Arrange cables through the inner section of the arm, around the elbow, and through the outer section Figure 3-9. Routing Cables through the Arm 2. Arrange cables through the slot on the inner section of the Arm. Secure cables in the cable arm using the hook-and-loop cables supplied with the NetServer. 3. With the cable arm still in the unextended position, place cables in the outer section of the arm and secure them with cable ties. Drape the cables through the fingers of the Cable Guide but do not secure them yet. 4. Prepare to extend the NetServer from the front of the rack by removing the front bezel and extending the anti-tip foot. 43