HP LH4r HP Ultra/Wide SCSI 4 GB and 9 GB Hard Disk Drive - Page 30
Mount the Drive in Shelf 3 or€4, Step 3: Connect the Drive
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Chapter 3 Mount the Drive in the NetServer E 45 Mount the Drive in Shelf 3 or 4 • Remove the drive mounting tray from the system. (See Figure 3-2.) Figure 3-2. Hard Disk Drive Mounting Tray • Align the four screw holes in the bottom of the NetServer E 45 tray with the four screw holes in the bottom of the drive. • Loosely install all of the screws, then tighten the screws to no more than eight inch-pounds (0.9 newton-meter). • Place the tray in the shelf opening and slide the tray into the shelf. • Align the screw holes at the front of the tray with the holes in the front of the chassis. • Loosely install all screws, then tighten each screw to no more than eight inch-pounds (0.9 newton-meter). Step 3: Connect the Drive Connect the SCSI data cable and power cable and complete the drive installation. The SCSI cable is connected to the SCSI connector on the SCSI host bus adapter board. The correct cable for HP Ultra SCSI-3 drives has an active termination module on one end of the cable. The active termination module is easy to recognize, because it looks different from the other connectors on the cable. The cable bundled with your system is actively terminated. 26