HP LH4r HP Ultra/Wide SCSI 4 GB and 9 GB Hard Disk Drive - Page 5
Prepare Drive for Installation, Introduction, General Installation Steps
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
1 Prepare Drive for Installation Introduction This chapter describes the tools, setup information and the steps necessary to install a SCSI hard disk drive into an HP NetServer. The drives documented in this guide are listed in Table 1-1. Table 1-1. Hard Disk Drive Product Numbers HP Product Number D4910A Capacity1 4.26 GB D4911A 9.10 GB General Installation Steps In general, the steps for installing a hard drive are shown below. Please refer to the detailed instructions in each step before attempting to install your drive. 1. Prepare for Installation 2. Determine the Drive Type 3. Set the SCSI Address 4. Connect SCSI Cable Adapter (if required) 5. Mount the Drive in the System 6. Connect the Drive Activity Light (if appropriate) 7. Connect the Drive 8. Configure the Drive CAUTION In a few cases, drives with the same product number can be of different types and require different jumper settings. If your drive does not match the type in the figure, check the other figures for the matching type. 1 The operating system may report a different capacity. 1