HP LH4r HP Ultra/Wide SCSI 4 GB and 9 GB Hard Disk Drive - Page 32
Press the Reset button on the system or press the, Wait until all drives reach full speed.
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Chapter 3 Mount the Drive in the NetServer E 45 CAUTION No low level format is needed. HP performs the low-level format at the factory. • Initialize the file system, using the operating system format utility. NOTE If you are experiencing problems with the drive, watch the messages on your monitor while the system boots. A message appears if a drive is not recognized by the HP NetServer (which happens when the HP NetServer attempts to communicate with a drive before the drive has finished spinning up). If the system did not recognize a hard drive: • Wait until all drives reach full speed. • Press the Reset button on the system or press the Ctrl+Alt+Del hot-key combination to restart the HP NetServer without powering it down. Do not power-down (power-cycle) the system to restart it, as this causes all the drives to stop spinning. 28