HP LH6000r HP Netserver Fibre Channel HBA Guide - Page 14
Connecting Cables
![]() |
View all HP LH6000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Connecting Cables 1. If you are using an optical GBIC module, remove the dust plug covers protecting the optical connectors before inserting the fibre-channel cable. Save the dust plug covers for future use. 2. Select the correct cable that matches the GBIC you installed and install the end connectors into the GBIC. The GBIC and Fibre Channel cable are keyed, so they can only fit one way. Refer to Figure 2-3. on page 8 for optical cable connection and Figure 2-4. on page 9 for copper cable connection. 3. Support the Fibre Channel cable so that you do not have a bend radius of less than 3 inches. 4. Support and route the Fibre Channel cable to prevent damage from sharp edges or from being crushed by nearby equipment. Figure 2-3. Optical (SFF - LC) and Optical (SC) Cable Connector 8
![](/manual_guide/products/hewlettpackard-lh3000r-hp-netserver-fibre-channel-hba-guide-4cf6a8b/14.png)