HP LH6000r HP Netserver Fibre Channel HBA Guide - Page 15

Removing the GBIC

Get HP LH6000r - NetServer - 0 MB RAM PDF manuals and user guides View all HP LH6000r manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

Figure 2-4. Copper Cable Connector Removing the GBIC To remove the GBIC, follow these steps: 1. Remove the Fibre Channel cable. (a) If you are using the HSSDC Copper Cable, squeeze the tab to remove. (See Figure 2-6. on page 10.) 2. (a) If you are using an optical GBIC, flip the bar of the GBIC to the "OPEN" position and pull to remove. (See Figure 2-5. on page 10.) (b) If you are using the HSSDC Copper GBIC, squeeze the tabs on both sides of the GBIC. (See Figure 2-6. on page 10.) 3. Pull the module out of the receptacle. 4. For optical GBICs, reinsert the dust plug. 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
9
Figure 2-4. Copper Cable Connector
Removing the GBIC
To remove the GBIC, follow these steps:
1. Remove the Fibre Channel cable.
(a) If you are using the HSSDC Copper Cable, squeeze the tab to
remove. (See Figure 2-6. on page 10.)
2. (a) If you are using an optical GBIC, flip the bar of the GBIC to the
“OPEN” position and pull to remove. (See Figure 2-5. on page 10.)
(b) If you are using the HSSDC Copper GBIC, squeeze the tabs on both
sides of the GBIC. (See Figure 2-6. on page 10.)
3. Pull the module out of the receptacle.
4. For optical GBICs, reinsert the dust plug.