HP LaserJet 5200 Service Manual - Page 274
Tray-behavior options, To set Use Requested Tray, To set Manually Feed Prompt
View all HP LaserJet 5200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 274 highlights
5. Press or to select the desired option, and then press . 6. Press Menu to exit the menu. Tray-behavior options Four user-defined options are available for tray behavior: ● USE REQUESTED TRAY. Selecting EXCLUSIVELYensures that the printer does not automatically select another tray when you indicate that a specific tray should be used. Selecting FIRST allows the printer to pull from a second tray if the specified tray is empty. EXCLUSIVELY is the default setting. ● MANUALLY FEED PROMPT. If you select ALWAYS (the default value), the system always shows a prompt before pulling from the multipurpose tray. If you select UNLESS LOADED, the system displays the prompt only if the multipurpose tray is empty. ● PS DEFER MEDIA. This setting affects how non-HP PostScript drivers behave with the printer. You do not need to change this setting if you use the drivers that HP supplies. If set to ENABLED, non-HP PostScript drivers use the same HP tray selection method as the HP drivers. If set to DISABLED, some non-HP PostScript drivers use the PostScript tray selection method instead of the HP method. ● SIZE/TYPE PROMPT. Use this item to control whether the tray configuration message and its corresponding prompts are shown whenever a tray is opened and closed. These prompts instruct you to change the type or size if the tray is configured for a different type or size than is loaded in the tray. To set Use Requested Tray 1. Press Menu. 2. Press to highlight CONFIGURE DEVICE, and then press . 3. Press to highlight SYSTEM SETUP, and then press . 4. Press to highlight TRAY BEHAVIOR, and then press . 5. Press to select USE REQUESTED TRAY. 6. Press or to select EXCLUSIVELY or FIRST, and then press . 7. Press Menu to exit the menu. To set Manually Feed Prompt 1. Press Menu. 2. Press to highlight CONFIGURE DEVICE, and then press . 3. Press to highlight SYSTEM SETUP, and then press . 4. Press to highlight TRAY BEHAVIOR, and then press . 5. Press to highlight MANUALLY FEED PROMPT, and then press . 6. Press or to select ALWAYS or UNLESS LOADED, and then press . 7. Press Menu to exit the menu. 254 Chapter 6 Troubleshooting ENWW