HP Latex 1500 Site Preparation Guide - Page 20
Storage area for materials, Storage conditions for substrate rolls
View all HP Latex 1500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Measurement B 1.5 m (4 ft 11 in) C 1.5 m (4 ft 11 in) D 4.27 m (14 ft 0.1 in) E 1.5 m (4 ft 11 in) F 1.5 m (4 ft 11 in) The ceiling of the room should be at a minimum height of 2.5 m (8 ft 3 in) above the floor. WARNING! The zone surrounding the printer should be considered a restricted access area and signaled accordingly. Only trained personnel should be operating within this area. Storage area for materials When planning a storage area for materials used with the printer, thought should not only be given to safety and convenience, but also to the fact that if inks and substrates are not stored in the appropriate temperature and humidity conditions, print results may be adversely affected. The storage area should be of sufficient size to accommodate adequate stocks of substrate rolls and inks. The storage area should be located near the print production area to minimize the lifting and maneuvering of heavy materials. The storage area should have a covered roof. It should be dry, well ventilated and able to provide protection from direct light. It is important that temperature and humidity are maintained within values specified for each substrate type. NOTE: Allow enough (environmentally controlled) space to store the printheads. This is indicated by the directional arrows on the printhead boxes. Storage conditions for substrate rolls Keep substrate rolls in their sealed wrapping material while they are placed in storage. Store substrate rolls vertically to avoid the migration of plasticizers in some materials. Move substrates from the storage area to the print production area at least 24 hours before use, so that they can reach the required moistness and operating temperature. NOTE: HP substrate rolls have a 12 month warranty when the substrate rolls are stored under optimal conditions. The warranty term varies depending upon the material and the manufacturer. Computer and networking requirements Requirements ● Print Care network functionality requires an Outbound connection to all the following addresses without a proxy. This means that an open internet connection allowing traffic on ports 80, 443 and 21 is needed. URL http://www.hp.com https://spcastweb01p.saas.hp.com http://spcw01.saas.hp.com HTTPS 443 X HTTPS 80 X X X FTP 21 X Used For Print Care / Production Analyzer Content and Data Connectivity 16 Chapter 2 Site preparation ENWW