HP Latex 1500 Site Preparation Guide - Page 21

NOTE: If needed, please instruct the customer IT to create routing rules that route around the proxy for these addresses. ● ActiveX must be installed on the computer. Install ActiveX if requested to do so. The anti-virus application must be configured not to block ActiveX controls. ActiveX must be enabled in Internet Explorer: Select Tools> Internet Options> Security tab. Then select the Internet zone and click Custom Level. Under ActiveX controls and plug-ins, enable: - Allow previously unused ActiveX controls to run without prompt - Automatic prompting for ActiveX controls ● A minimum upload speed of 256 bps is required. HP provides the following system components: HP-provided components ● HP Internal Print Server - PC and power cord. PC LAN card connections: 2 Ethernet ports, one for the e-box LAN cable to connect the printer to the PC, and the other to connect to the network - Monitor and power cord - Keyboard - Mouse - Windows 7 Embedded - HP Internal Print Server software - HP Scitex Print Care software - Symantec Antivirus - Webcam ● 1 Gb Ethernet cables Customer-provided components ● Ethernet LAN (minimum 100 Mb/s, optimum 1 Gb/s) connection ● RIP station and software ● CAT-6 LAN cable long enough to connect the printer to the network RIP requirements There are two RIPs offered by HP that may be used with the printer: ● HP Scitex ONYX Thrive 211 RIP: product number D9Z41A ● HP Scitex Caldera Grand RIP v10 Software: product number L5E74A The software and hardware requirements of these RIPs are as follows. ENWW Computer and networking requirements 17