HP Latex 2700 User Guide 4 - Page 9

● 1016 mm (40 in): 610-mm (24-in) and two 203-mm (8-in) tubes ● 1270 mm (50 in): 1067-mm (42-in) and 203-mm (8-in) tubes ● 1372 mm (54 in): 1067-mm (42-in) and 305-mm (12-in) tubes ● 1524 mm (60 in): 1067-mm (42-in), 305-mm (12-in) and 152-mm (6-in) tubes ● 1829 mm (72 in): 1067-mm (42-in), 610-mm (24-in) and 152-mm (6-in) tubes ● 1981 mm (78 in): 1067-mm (42-in), 610-mm (24-in) and two 152-mm (6-in) tubes ● 2032 mm (80 in): 1067-mm (42-in), 610-mm (24-in), 203-mm (8-in) and 152-mm (6-in) tubes ● 2489 mm (98 in): two 1067-mm (42-in), 203-mm (8-in) and 152-mm (6-in) tubes ● 2642 mm (104 in): two 1067-mm (42-in), 305-mm (12-in) and 203-mm (8-in) tubes ● 3200 mm (126 in): two 1067-mm (42-in), 610-mm (24-in), 305-mm (12-in) and 152-mm (6-in) tubes 1. Follow the whole loading procedure for the roll-to-freefall configuration. 2. Load an empty substrate core onto the output spindle. For dual-roll printing, load two cores of the same diameter onto a single spindle (it is not recommended to use a dual-roll spindle as the collector). 3. Use the buttons in the Internal Print Server to advance the substrate's leading edge until it reaches the core on the collector. 4. Tighten the substrate so that it is evenly tensioned, then attach the leading edge to the core with tape, first at the center and then at the sides. There should be no wrinkles or slackness across the substrate. 5. Use the buttons in the Internal Print Server again to advance the substrate so that a substrate loop is produced between the tension roller and the collector. 6. Place the tension bar into the substrate loop. NOTE: Loop detection is done in the center of the printer; so avoid putting your foot or any other object under the collector in the center. 7. Go to the Internal Print Server and click the Enable collector button (for the HP Latex 1500), or tap the Take-up reel button (for the HP Latex 2700 series). 6 Chapter 2 Substrate configurations