HP Latex 800 Site Preparation Guide - Page 5

1 Overview Your printer is supplied ready to use after a few simple installation procedures described in detail in the assembly instructions. It is important to read the information provided in the site preparation guide thoroughly and to ensure complete compliance with all installation and operation requirements. Safety procedures, warnings, cautions, and local regulations must all be adhered to. A well-prepared site helps to provide a smooth and easy installation. Documentation A full set of manuals are provided with your printer, and can also be downloaded. Manuals can be downloaded from: http://www.hp.com/go/latex700-800series/manuals. ● Introductory information ● Limited warranty ● Legal information ● Site preparation guide (this guide) ● Assembly instructions ● User guide Customer responsibility You are responsible for preparing the physical site for the installation of the printer. ● Prepare the building's electrical system to meet the printer's requirements and the Electrical Code requirements according to the local jurisdiction of the country where the equipment is installed. See Electrical configuration on page 8. NOTE: Make sure that a certified electrician reviews the setup and configuration of the electrical system used to power the printer. See Electrical configuration on page 8. ● Meet temperature and humidity requirements and ensure proper ventilation for the printer. See Environmental specifications on page 4. ● Meet all requirements for RIP, networking and printing supplies. See RIP workstation characteristics on page 7, Networking on page 7, and Printing supplies on page 8. ● Prepare the unloading route so that the printer can be unloaded and maneuvered into place. See Unloading route on page 3. Installation time schedule Allow a minimum of 3.5 hours for the installation of 700 series printers, and 3 hours for 800 series printers. The installer may require the help of another person to perform certain tasks during installation. Overview 1