HP Mini 1104 HP Mini 1104 - Maintenance and Service Guide - Page 44

protective sleeves must be installed on the antenna connectors

Get HP Mini 1104 PDF manuals and user guides View all HP Mini 1104 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 44 highlights

3. Remove the WWAN module by pulling the module away from the slot at an angle (3). NOTE: The WWAN module is designed with a notch (4) to prevent incorrect installation into the WWAN module socket. NOTE: If the WWAN antennas are not connected to the terminals on the WWAN module, the protective sleeves must be installed on the antenna connectors, as shown in the following illustration. Reverse this procedure to install the WWAN module. 36 Chapter 4 Removal and replacement procedures

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
3.
Remove the WWAN module by pulling the module away from the slot at an angle
(3)
.
NOTE:
The WWAN module is designed with a notch
(4)
to prevent incorrect installation into
the WWAN module socket.
NOTE:
If the WWAN antennas are not connected to the terminals on the WWAN module, the
protective sleeves must be installed on the antenna connectors, as shown in the following illustration.
Reverse this procedure to install the WWAN module.
36
Chapter 4
Removal and replacement procedures