HP OmniBook 2000 HP OmniBook Hardware Diagnostics - User Guide - Page 20

If a PC Component is Not Detected

Get HP OmniBook 2000 - Notebook PC PDF manuals and user guides View all HP OmniBook 2000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

Hardware Detection If a PC Component is Not Detected If a PC Component is Not Detected If a component or device in your PC (such as a hard disk drive) is not detected, do the following: 1. Check the list of components that OmniBook Hardware Diagnostics typically detects (this is on page 2-5). If the non-detected component is not in this list, then there is no error and the situation is normal. If the non-detected component is in this list, continue to the next step. 2. Check that the PC is correctly configured in the PC's Setup program. (Refer to page 1-5 for more information about the PC's Setup program.) 3. Refer to the User's Guide that came with the PC for information about troubleshooting the PC. 4. Run the Hardware Diagnostics and proceed to the basic system test. Note OmniBook Hardware Diagnostics does not test components that have not been detected. However, we recommend that you continue with the basic system test to verify that the underlying components are functioning correctly. For example: a PC has a CD-ROM drive installed. Even if the CD-ROM drive is not detected, running the basic system test will ensure the correct functioning of the IDE system that supports the drive. We also recommend running the advanced section to verify that the corresponding tests are enabled. 5. If the problem persists, contact your local or HP-dedicated support agent for assistance. 2-6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
Hardware Detection
2-6
If a PC Component is Not Detected
If a component or device in your PC (such as a hard disk drive) is not detected, do
the following:
1.
Check the list of components that OmniBook Hardware Diagnostics typically
detects (this is on page 2-5).
If the non-detected component is not in this list, then there is no error and the
situation is normal.
If the non-detected component is in this list, continue to the next step.
2.
Check that the PC is correctly configured in the PC’s Setup program. (Refer to
page 1-5 for more information about the PC’s Setup program.)
3.
Refer to the User’s Guide that came with the PC for information about
troubleshooting the PC.
4.
Run the Hardware Diagnostics and proceed to the basic system test.
OmniBook Hardware Diagnostics does not test components that have not been
detected. However, we recommend that you continue with the basic system test to
verify that the underlying components are functioning correctly. For example: a PC
has a CD-ROM drive installed. Even if the CD-ROM drive is not detected, running the
basic system test will ensure the correct functioning of the IDE system that supports
the drive. We also recommend running the advanced section to verify that the
corresponding tests are enabled.
5.
If the problem persists, contact your local or HP-dedicated support agent for
assistance.