HP Pavilion 15-b100 HP Pavilion Sleekbook 15 and HP Pavilion Ultrabook 15 Main - Page 65
that secure the system board to the base enclosure., Remove the two Phillips screws
View all HP Pavilion 15-b100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
NOTE: The heat sink on your system board may appear different from the heat sink shown. 1. Disconnect the following cables from the system board: (1) Display panel cable (2) Speaker cable (3) Fan power connector 2. Remove the power connector bracket Phillips screw (1) and remove the power connector bracket (2). 3. Remove the two Phillips screws (3) that secure the system board to the base enclosure. 4. Lift the left side of the system board (1) until it rests at an angle. 5. Remove the system board by sliding it up and to the left at an angle (2). Component replacement procedures 57
NOTE:
The heat sink on your system board may appear different from the heat sink shown.
1.
Disconnect the following cables from the system board:
(1)
Display panel cable
(2)
Speaker cable
(3)
Fan power connector
2.
Remove the power connector bracket Phillips screw
(1)
and remove the power connector bracket
(2)
.
3.
Remove the two Phillips screws
(3)
that secure the system board to the base enclosure.
4.
Lift the left side of the system board
(1)
until it rests at an angle.
5.
Remove the system board by sliding it up and to the left at an angle
(2)
.
Component replacement procedures
57