HP Pavilion zt1200 HP Pavilion zt1000/xz300 and Omnibook xt1500 Series Noteboo - Page 49

Removing the System SDRAM Module

Get HP Pavilion zt1200 - Notebook PC PDF manuals and user guides View all HP Pavilion zt1200 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 49 highlights

Reassembly Notes • Carefully press the SDRAM module into the connector at an angle of about 30°, until it is fully inserted. Then press down on both sides of the module until the latches snap closed. Figure 18. Installing an Expansion SDRAM Module Removing the System SDRAM Module Removal Procedure 1. Unplug the AC adapter, if present, and remove the battery. 2. Remove the keyboard cover (page 42). 3. Open the keyboard (page 46, steps 1 though 5). You don't need to disconnect the keyboard cable. 4. Press outward to release the latches at the sides of the SDRAM module (so that the free edge of the module pops up), then pull the module out of the connector. Figure 19. Removing the System SDRAM Module Reassembly Notes • Carefully press the SDRAM module into the connector at an angle of about 30°, until it is fully inserted. Then press down on both sides of the module until the latches snap closed. zt1000/xz300 and xt1500 Series Troubleshooting and Self-Repair Guide Removing and Replacing Parts 49

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
zt1000/xz300 and xt1500 Series
Removing and Replacing Parts
49
Troubleshooting and Self-Repair Guide
Reassembly Notes
•
Carefully press the SDRAM module into the connector at an angle of about 30
°
, until it is fully
inserted. Then press down on both sides of the module until the latches snap closed.
Figure 18. Installing an Expansion SDRAM Module
Removing the System SDRAM Module
Removal Procedure
1. Unplug the AC adapter, if present, and remove the battery.
2. Remove the keyboard cover (page 42).
3. Open the keyboard (page 46, steps 1 though 5). You don
’
t need to disconnect the keyboard cable.
4. Press outward to release the latches at the sides of the SDRAM module (so that the free edge of
the module pops up), then pull the module out of the connector.
Figure 19. Removing the System SDRAM Module
Reassembly Notes
•
Carefully press the SDRAM module into the connector at an angle of about 30
°
, until it is fully
inserted. Then press down on both sides of the module until the latches snap closed.