HP ProLiant 1500 ProLiant Server Troubleshooting Guide - Page 263
server setup utility to, recon NVRAM to reflect
View all HP ProLiant 1500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 263 highlights
ADU Error Messages Table D-1: Array Diagnostic Utility (ADU) Error Messages continued Message Description Recommended Action Loose cable detected - logical drives may be marked FAILED until corrected Controller is unable to communicate with one or more physical drives, probably because of a cabling problem. Logical drives may be in a FAILED state until the condition is corrected, preventing access to data on the controller. Check all controller and drive cable connections. Mirror data miscompare Data was found at reset initialization in the posted-write memory; however, the mirror data compare test failed resulting in that data being marked as invalid. Data loss is possible. Replace the array accelerator board. No configuration for array accelerator board The array accelerator board has not been configured. If the array accelerator board is present, run ACU to configure the board. NVRAM configuration present, controller not detected EISA NVRAM has a configuration for an array controller, but there is no board in this slot. Either a board has been removed from the system or a board has been placed in the wrong slot. Place the array controller in the proper slot, or run the server setup utility to reconfigure NVRAM to reflect the removal or new position. One or more drives is unable to support redundant controller operation At least one drive in use does not support redundant controller operation. Replace the drive that does not support redundant controller operation. Other controller indicates different hardware model The other controller in the redundant controller configuration is a different hardware model. Be sure that both controllers are using the same hardware model. If they are, make sure that controllers are fully seated in their slots. Other controller indicates different firmware version The other controller in the redundant controller configuration is using a different firmware version. Be sure that both controllers are using the same firmware revision. continued HP Servers Troubleshooting Guide D-13