HP Professional ap550 Compaq Professional Workstation AP550 Maintenance & - Page 39
Front Bezel
View all HP Professional ap550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
3-6 Compaq Professional Workstation AP550 Maintenance and Service Guide Front Bezel To remove the front bezel (158278-001): 1. Perform the steps in the "Service Preparations" section as previously shown. CAUTION: Before removing the workstation access panel, ensure that the workstation is turned off, all cables are disconnected from the back of the workstation, and the power cord is disconnected from the grounded AC outlet. 2. Remove the workstation access panel. 3. Press in on the two release tabs 1, then rotate the front bezel away from the chassis to remove it from the workstation 2. 2 1 2 Figure 3-5. Removing the front bezel To replace the front bezel, reverse the above procedure. NOTE: When replacing the front bezel, be sure the bottom hinge points are properly placed in the chassis before rotating the front bezel back into its original position.