HP Professional ap550 Compaq Professional Workstation AP550 Maintenance & - Page 85
then lift the board up and out of the chassis, Tilt the rear of the board up
View all HP Professional ap550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
3-52 Compaq Professional Workstation AP550 Maintenance and Service Guide 8. Remove the retaining screws that secure the system board to the chassis 1. 9. Slide the board 1/2-inch toward the front of the chassis to clear the I/O panel connectors 2. 10. Tilt the rear of the board up 3, then lift the board up and out of the chassis 4. 1 1 1 4 3 2 Figure 3-45. Removing the system board from the chassis To install a new system board, reverse the above procedure. CAUTION: Damage to the system board could result if all the power cables are not properly reconnected to the system board. NOTE: When installing the system board, properly align the board in the chassis by inserting the screw nearest the power supply first.
3-52
Compaq Professional Workstation AP550 Maintenance and Service Guide
8.
Remove the retaining screws that secure the system board to the chassis
1
.
9.
Slide the board 1/2-inch toward the front of the chassis to clear the I/O panel
connectors
2
.
10.
Tilt the rear of the board up
3
, then lift the board up and out of the chassis
4
.
1
2
1
1
3
4
Figure 3-45.
Removing the system board from the chassis
To install a new system board, reverse the above procedure.
CAUTION:
Damage to the system board could result if all the power cables are not properly
reconnected to the system board.
NOTE:
When installing the system board, properly align the board in the chassis by inserting the screw
nearest the power supply first.