HP R1500 UPS R6000 Models User Guide - Page 35
Battery Data, Firmware Version, Select Battery Data on the Main Menu
View all HP R1500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
LCD Configuration and Status Table 3-4: Active Alarms continued LCD Display Explanation x Alarms The UPS switched to battery power. The LED illuminates yellow. UPS On Battery x Alarms Load Power Off The UPS is no longer protecting its load devices and there is no utility voltage powering the devices. x Alarms An automatic battery test failed. Battery replacement is imminent. Battery Test Failed x Alarms Site Wiring Fault There is no ground connection between utility power and the UPS, or the line and neutral connections between utility power and the UPS are reversed. This is disabled for 200 V and 208 V configurations. Battery Data Select Battery Data on the Main Menu to display the amount of charge on the battery. Main Menu → Battery Data When the UPS goes into Battery mode, the graph shows the remaining battery energy in 10 percent increments. This example shows a battery charged to 100 percent. Battery Discharge Firmware Version Select Firmware Version from the Main Menu to view the firmware versions for the UPS components. Main Menu → Firmware Version This menu selection shows the control board firmware version. Control Board Version x. x x This menu selection shows the communication board firmware version. Communication Bd Version x. x x 3-8 HP Uninterruptible Power System R6000 Models User Guide