HP Scitex FB10000 Geffen TS Error 67022 - Page 5

Error ID: 67022: Safety - Rear rising media detector activated (loader side) Sensor or wiring failure 1. Check the wiring between the sensor and the 2SDI3 B&R module. 2. If the wiring is OK and LEDs 9 & 10 are off, then replace the sensor FB10000 Error Messages Troubleshooting Top Flowchart Rising media flap calibration Warning! Always push the emergency when working on the machine; if you work alone make sure to take the emergency key with you. Preparation before Rising Media Flap calibration 1. Ensure that machine is fully functional before performing this calibration. 2. Make sure that the Rising Media flaps are fully up. • Special Tools required for this calibration procedure: CX189-02910 - 3 X RM_CALIBRATION_TOOL_ASSY • Caliper. 3. Make sure that the Vacuum X table is clean in the area you intend to place the calibration jig. 4. Make sure that the ink beam surface is clean in the area you intend to place the calibration jig. 5