HP StorageWorks 4/64 Brocade Fabric OS Command Reference Guide v6.0.0 (53-1000 - Page 632
supportSave, options or interactively. To display the current FTP parameters, run
View all HP StorageWorks 4/64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 632 highlights
2 supportSave supportSave Saves RASLOG, TRACE, supportShow, core file, FFDC data, and other support information Synopsis supportsave supportsave [-n] [-c] [-k] [-u user_name -p password] -h host_ip -d remote_dir [-l ftp| scp] supportsave [-R] supportsave [-U -d remote_dir] Description Use this command to collect RASLOG, TRACE, supportShow, core file, FFDC data and other support information to a remote FTP location. On platforms that support USB, the information can also be stored on an attached USB device.On a dual CP system, the local and remote CP's information will be saved. SupportShow information is available on Active and Standby CPs. To reduce the chance of missing the correct trace dump, supportSave will retrieve old (the existing dump before the command) and new (the dump triggered by the command) trace dumps. The core files and panic dumps remain on the switch after the command.The FFDC data will be removed after the command. If there are BP blades installed in the switch, it will also retrieve support file (as a.tar.gz file) from each slot. This command accepts IPv4 and IPv6 addresses. If the configured IP address is in IPv6 format, the RAS auto file transfer and event notification to syslog will not work in the case where the FOS version is downgraded. It is required to re-configure auto file transfer and syslog with IPv4 IP addresses. Operands When invoked without operands, this command goes into interactive mode.The following operands are optional: -n Does not prompt for confirmation. This operand is optional; if omitted, you are prompted for confirmation. -c Uses the FTP parameters saved by the supportFtp command. This operand is optional; if omitted, specify the FTP parameters through command line options or interactively. To display the current FTP parameters, run supportFtp (on a dual-CP system, run supportFtp on the active CP). The -c operand is mutually exclusive with -u, -p, -h, and -d. -k Specifies supportFtp auto file transfer configuration to transfer only core and ffdc files in non-interactive mode. -u user_name Specifies the user name for the FTP server. This operand is optional; if omitted, anonymous FTP is used. -p password Specifies the password for the FTP server. This operand is optional; if omitted, anonymous FTP is used. -h host_ip Specifies the IPv4 or IPv6 for the FTP server. -d remote_dir Specifies the remote directory where to transfer the file. -R Removes all core files on the CP and BP. It is exclusive with all other options. -l ftp|scp Specifies the FTP or SCP protocol. 606 Fabric OS Command Reference 53-1000599-01