HP StorageWorks Modular Smart Array 1000 HP StorageWorks 1000/1500 Modular Sma - Page 18

Using the Support Software CD (Linux), Storage Area Network SAN. If the MSA is uncon

Get HP StorageWorks Modular Smart Array 1000 PDF manuals and user guides View all HP StorageWorks Modular Smart Array 1000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

NOTE: Your menu may differ slightly from the following example. 5. Click View Contents to review notes and information about the contents of the CD. IMPORTANT: • Install the HBA driver before the Windows Event Notification Service. • As a time-saving measure when installing multiple components from the CD, do not restart the server each time when prompted. Instead, restart the server after all components are installed. 6. Update each item, as needed, following the onscreen instructions 7. When finished, click Exit, remove the CD from the CD-ROM drive, and then restart the server. 8. Repeat these installation procedures on each server with access to the MSA. Using the Support Software CD (Linux) 1. With the HBAs installed in the server, apply power, start your Linux operating system, and log on as the root user. IMPORTANT: If LUNs on the MSA are already being presented to the server, disconnect the MSA from the Storage Area Network (SAN). If the MSA is unconfigured, the MSA can be connected to the SAN. 2. Insert the MSA Support Software CD into the CD-ROM drive of the server, and then mount the CD-ROM. 18 Updating the components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
NOTE:
Your menu may differ slightly from the following example.
5.
Click
View Contents
to review notes and information about the contents of the CD.
IMPORTANT:
•
Install the HBA driver before the Windows Event Noti
fi
cation Service.
•
As a time-saving measure when installing multiple components from the CD, do
not restart the server each time when prompted. Instead, restart the server after all
components are installed.
6.
Update each item, as needed, following the onscreen instructions
7.
When
fi
nished, click
Exit
, remove the CD from the CD-ROM drive, and then restart the server.
8.
Repeat these installation procedures on each server with access to the MSA.
Using the Support Software CD (Linux)
1.
With the HBAs installed in the server, apply power, start your Linux operating system, and log on
as the root user.
IMPORTANT:
If LUNs on the MSA are already being presented to the server, disconnect the MSA from the
Storage Area Network (SAN). If the MSA is uncon
fi
gured, the MSA can be connected to
the SAN.
2.
Insert the MSA Support Software CD into the CD-ROM drive of the server, and then mount the
CD-ROM.
18
Updating the components