HP StorageWorks Modular Smart Array 1000 HP StorageWorks 1000/1500 Modular Sma - Page 30

Step Description (continued) Check 9 Insert the HP StorageWorks Modular Smart Array 1000/1500 Support Software CD F and install the required applications and drivers from the CD: • Qlogic/Emulex HBA driver (restart the server if required) • Array Configuration Utility (ACU) software • HP MPIO Full-Featured DSM for Windows (restart the server if required) • HP MPIO DSM Manager • (Optional) Array Configuration Utility CLI (ACUCLI) software • (Optional) Array Diagnostics Utility (ADU) software 10 Remove the HP StorageWorks Modular Smart Array 1000/1500 Support Software F CD from the CD drive. 11 (For systems with HP Secure Path MPIO software only) F Enable HP Secure Path services and drivers: • From the server console desktop, select Start>Run. • In the Run window, enter devmgmt.msc and then click OK to open the Device Manager Utility. • Select SCSI and RAID controllers, right-click the Compaq Secure Path Disk Bus device, and then select Enable. • Close the Device Manager Utility. • From the server console desktop, select Start>Run. • In the Run window, enter services.msc and then click OK to open the Services Utility. • In the right pane, double-click Compaq HS_ Service. • Change the Startup type from Disabled to Automatic. • Click OK to close the window. • In the right pane, double-click Secure Path Agent. • Change the Startup type from Disabled to Automatic. • Click OK to close the window. • If HP Secure Path Manager software is installed, double-click Element Manager for Secure Path in the right pane to open the Element Manager for Secure Path Properties window. • Change the Startup type from Disabled to Automatic. • Click OK to close the window. • Close the Services Utility. 12 Shutdown the server node. F Note: Skip this step if this is the only node running in the cluster. 13 Go to migration step 1 to migrate all other server nodes within the F cluster. 14 Temporarily disable any applications on the system that have I/O on the MSA disk F array. 15 From the back of the server node, reconnect the Fibre Channel cable to the HBA card. F 16 Using the MSA1000/1500 firmware updating guide, upgrade the HP StorageWorks F MSA1000/1500 controller firmware from active/passive to active/active. 17 When the MSA firmware upgrade is complete, shut down the server node. F 30 Migrating multi-path cluster systems