HP Tc2120 hp server tc2120 troubleshooting guide - Page 12
Configuration Problems, Printer Problems, Symptom, Action
UPC - 808736945332
View all HP Tc2120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Chapter 6 Troubleshooting 16. Reinstall remaining components one at a time once video returns. One of the removed components may have been causing the no video problem. After all the components are reinstalled, reset the HP Server's BIOS configuration switch back to the appropriate setting. Configuration Problems Symptom: · The configuration cannot be saved and the battery loses power. Action: Refer to this section if the server frequently loses date and time that may be caused by the battery losing power. 1. Review the Troubleshooting Checklist before you continue. 2. If the server frequently loses the time and date, replace the battery. The battery is attached to the system board. 3. Set the new date and time, and reset the configuration parameters using the Setup Utility, if necessary. 4. To start the (BIOS) Setup Utility, boot or reboot the system and press F10 when prompted. 5. Turn off AC power to the server, then back on again and reboot to see if the date and time was saved. 6. If date and time are still requested, and the battery is good, perform the next procedure, below. WARNING There is a danger of explosion if the battery is incorrectly installed. For your safety, never attempt to recharge, disassemble, or burn the old battery. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer's instructions. Symptom: · The configuration information is frequently lost and the battery is good. Action: If the battery is good and you cannot save system configuration, do the following: 1. Review the Troubleshooting Checklist before you continue. BIOS configuration information is saved in the CMOS memory. 2. If you continue to lose configuration information and the battery is good, or you cannot save the BIOS information to CMOS memory: o Check the battery socket terminals for corrosion or loose connections. If this does not correct the problem, call your HP Customer Support Center before replacing any more parts. Printer Problems If the printer does not work, do the following: 1. Verify that the AC power cord is plugged into the power source and the printer. 2. Ensure the printer power switch is ON and the AC outlet is working. 3. If the printer is plugged into a multiple-outlet box, make sure the switch on the outlet box is turned on and the circuit breaker (if applicable) is not tripped. 4. Ensure the printer is online and available for printing. 11