HP Vectra XE310 hp vectra xe310, upgrade guide - Page 22

Installing an Optical Drive, Replacing a Drive in the Top Bay

Page 22 highlights

Upgrading and Replacing PC Hardware Installing an Optical Drive An optical drive can be a CD-ROM, DVD-ROM, CD-RW or DVD-RW drive. Replacing a Drive in the Top Bay WARNING To avoid electrical shock and harm to your eyes by laser, do not open the laser module. The laser module should be serviced by service personnel only. Do not attempt to make any adjustment to the laser unit. Refer to the label on the CD-ROM for power requirements and wavelength. This product is a class 1 laser product. For your safety, disconnect the power cord and all external cables. 1 Switch off the PC, disconnect the power cord and remove the PC's side panel and air flow guide (refer to "Removing and Replacing the Side Panel & Air Flow Guide" on page 12). 2 Disconnect the cables from the rear of the drive. 3 Remove the two retaining screws, noting carefully the position of these screws. 22

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

Upgrading and Replacing PC Hardware
Installing an Optical Drive
An optical drive can be a CD-ROM, DVD-ROM, CD-RW or DVD-RW drive.
Replacing a Drive in the Top Bay
WARNING
To avoid electrical shock and harm to your eyes by laser, do not open the laser module. The laser module should be serviced
by service personnel only. Do not attempt to make any adjustment to the laser unit. Refer to the label on the CD-ROM for
power requirements and wavelength. This product is a class 1 laser product.
For your safety, disconnect the power cord and all external cables.
1
Switch off the PC, disconnect the power cord and remove the PC’s side panel and air flow guide (refer
to “Removing and Replacing the Side Panel & Air Flow Guide” on page 12).
2
Disconnect the cables from the rear of the drive.
3
Remove the two retaining screws, noting carefully the position of these screws.
22±