HP Vectra XU 5/XX HP Vectra XU PC Series - Setting Up Guide - Page 6
Removing the Cover
View all HP Vectra XU 5/XX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
• Before installing accessory boards, check available system resources and change the board's switch settings if necessary. (Refer to Installing Accessory Boards.) • After installing accessories, check the PC's configuration by running SETUP. (Refer to "Configuring Your PC".) If you installed ISA accessory boards, run the ISA Configuration Utility in the Plug and Play group, in Windows. (Refer to Installing Accessory Boards, later in this chapter.) WARNING For your safety, never remove the PC's cover without first removing the power cord, and any connection to a telecommunications network. Some large displays are heavier than one person can lift safely. Refer to the display's documentation. If in doubt, never lift a large display without help. Removing the Cover 1. Switch the PC and display OFF. 2. Disconnect the power cords from the power outlets. Disconnect the power cords from the PC and display, then remove the display. HP Vectra XU PC - Setting Up Installing Accessories • 6