HP Virtual Connect Flex-10/10D Module Enterprise Edition for BLc7000 HP BladeS - Page 18

Downgrades, Overview, Restrictions

Get HP Virtual Connect Flex-10/10D Module Enterprise Edition for BLc7000 PDF manuals and user guides View all HP Virtual Connect Flex-10/10D Module Enterprise Edition for BLc7000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

Downgrades Overview This feature enables you to downgrade to a previously installed and running version of VC. Restrictions The following restrictions apply: • You must be running VC version 3.70 or higher to perform a downgrade. • You cannot downgrade to a VC version lower than v3.17. • A previous upgrade must have been performed on the configuration using VCSU 1.7.0. • All servers in the domain must be powered off. • Multiple, consecutive firmware downgrades are not allowed. • You can downgrade only to the version previously installed and running on the primary module. • The VC configuration, including physical connections, uplink port connections, and module positions in the enclosure, must be identical to the target downgrade configuration. • The VC credentials must be the same before and after the downgrade. After the downgrade, you cannot change the password for the account used to perform the downgrade. • The primary E-net module must be in the lowest bay number. Downgrades 18

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
Downgrades 18
Downgrades
Overview
This feature enables you to downgrade to a previously installed and running version of VC.
Restrictions
The following restrictions apply:
•
You must be running VC version 3.70 or higher to perform a downgrade.
•
You cannot downgrade to a VC version lower than v3.17.
•
A previous upgrade must have been performed on the configuration using VCSU 1.7.0.
•
All servers in the domain must be powered off.
•
Multiple, consecutive firmware downgrades are not allowed.
•
You can downgrade only to the version previously installed and running on the primary module.
•
The VC configuration, including physical connections, uplink port connections, and module positions in
the enclosure, must be identical to the target downgrade configuration.
•
The VC credentials must be the same before and after the downgrade. After the downgrade, you cannot
change the password for the account used to perform the downgrade.
•
The primary E-net module must be in the lowest bay number.