HP Workstation x1000 hp workstation x1000 - getting started guide (English) - Page 44
There is an image during boot but then the screen goes blank, Table 2-2, Your Workstation Has
View all HP Workstation x1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Table 2-2 troubleshooting your workstation solving hardware problems Your Workstation Has a Hardware Problem The monitor's power cord is correctly connected. Connect the power cord - ensure it is plugged into a working grounded power outlet and into the monitor. The graphics card is installed and the monitor (video) cable is correctly connected. Connect the monitor (video) cable - ensure it is properly connected to both the workstation and the monitor. Ensure that the cable is connected to the graphics card's connector. The monitor's brightness and contrast settings are correctly set. Check the settings using the monitor's OSD (on-screen display) or using controls on the front of the monitor. There is an image during boot but then the screen goes blank. Make sure... How The monitor settings in your workstation are compatible with your monitor. • Windows 2000: Restart the workstation. The Startup screen is displayed. When prompted, press F8 and then start the workstation in VGA mode. When the workstation has started, double-click on the Display icon in your workstation's Control Panel, then click on the Settings button. Use the sliding control to reset the resolution. • Windows NT: Enter VGA mode when prompted during start-up. If the Workstation starts and you still have a problem, run HP e-DiagTools (refer to page 49). 44 Chapter 2
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
-
33
-
34
-
35
-
36
-
37
-
38
-
39
-
40
-
41
-
42
-
43
-
44
-
45
-
46
-
47
-
48
-
49
-
50
-
51
-
52
-
53
-
54
-
55
-
56
-
57
-
58
-
59
-
60
-
61
-
62
-
63
-
64
-
65
-
66
-
67
-
68
-
69
-
70