HP XM600 hp kayak xm600, installing and replacing hardware parts in your pc wo - Page 17

Installing a Second Hard Disk Drive

Get HP XM600 - Kayak - 128 MB RAM PDF manuals and user guides View all HP XM600 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

Installing and Replacing Hardware Parts in Your PC Workstation Installing a Second Hard Disk Drive Installing a Second Hard Disk Drive 1 Switch off the display and PC Workstation. Disconnect all power cables and any LAN or telecommunications cables. 2 Remove the PC Workstation's cover and front bezel (refer to page 3 for these instructions). 3 Remove the two retaining screws from the hard disk drive tray located on the front of the chassis, then carefully slide the tray towards the rear of the PC. 4 Insert the new drive into the drive tray and secure it to the tray using the screw provided with the hard disk drive tray. Only one screw is required. 5 Carefully put the drive tray back into the PC, and secure it in position using the two retaining screws that you removed earlier. 6 Connect the power cable and the data cable to the rear of the new hard disk drive. The connectors are shaped to go in one way only. If you are not sure which connector to use, refer to "Installing Mass Storage Devices", on page 13. 7 Replace the front bezel and PC Workstation's cover (refer to page 3). Reconnect all the power and telecommunications cables. 8 Turn to page 25 to complete the installation. 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
Installing and Replacing Hardware Parts in Your PC Workstation
Installing a Second Hard Disk Drive
17
Installing a Second Hard Disk Drive
1
Switch off the display and PC Workstation. Disconnect all power cables
and any LAN or telecommunications cables.
2
Remove the PC Workstation’s cover and front bezel (refer to page 3 for
these instructions).
3
Remove the two retaining screws from the hard disk drive tray located
on the front of the chassis, then carefully slide the tray towards the rear
of the PC
.
4
Insert the new drive into the drive tray and secure it to the tray using the
screw provided with the hard disk drive tray. Only one screw is required.
5
Carefully put the drive tray back into the PC, and secure it in position
using the two retaining screws that you removed earlier.
6
Connect the power cable and the data cable to the rear of the new hard
disk drive.
The connectors are shaped to go in one way only
. If you
are not sure which connector to use, refer to "Installing Mass Storage
Devices", on page 13.
7
Replace the front bezel and PC Workstation’s cover (refer to page 3).
Reconnect all the power and telecommunications cables.
8
Turn to page 25 to complete the installation.